Quick answer: a 2-car garage of about 484 sq ft with a 9-foot ceiling needs about 13,500 BTU if insulated and 17,600 BTU if not. A 1-car garage needs about 10,200 BTU uninsulated, which is a 12,000 BTU mini split.
Garage BTU chart
Calculated for a 9-foot ceiling, normal sun and a moderate climate. Hot climates add 10% and desert climates add 20%.
| Garage | Sq ft | Insulation | BTU needed | Mini split |
|---|---|---|---|---|
| 1-car | 264 | Insulated | 7,900 | 9,000 BTU |
| 1-car | 264 | Not insulated | 10,200 | 12,000 BTU |
| 2-car | 484 | Insulated | 13,500 | 18,000 BTU |
| 2-car | 484 | Not insulated | 17,600 | 18,000 BTU |
| 3-car | 704 | Insulated | 20,300 | 24,000 BTU |
| 3-car | 704 | Not insulated | 26,300 | 30,000 BTU |
What makes garages hard to cool
The garage door is the biggest problem. A standard steel door is a large, thin, dark panel, often facing the street and the afternoon sun. Many garages also share only one wall with the house, have no insulation in the other three and sit on a slab that stores heat. Air leaks around the door and ceiling hatch bring in outside air all day.
That is why this calculator defaults to an uninsulated garage with a 9-foot ceiling, and adds 30% to the room chart for no insulation and 15% for partial insulation.
Cheaper ways to cut the load first
- Add an insulated garage door or a foam panel kit to the existing door.
- Replace the door's bottom seal and weatherstrip the sides and top.
- Insulate the ceiling if there is a room or attic above it.
- Seal gaps where pipes and wires pass through the walls.
Each of these can bring a garage down from the not insulated row to the partly insulated one, which often means a smaller unit and lower bills.
Installation notes
Garages often hold fuel, solvents and cars, so check local code and the manufacturer's manual for where an indoor head can go. Keep the outdoor unit clear of the driveway. Most 18,000 BTU and larger units need a dedicated 240V circuit; have an electrician size it from the nameplate.
How this calculator works
The starting point is the room sizing chart that ENERGY STAR publishes for room air conditioners. It gives a capacity in BTU per hour for each band of floor area, and it assumes an 8-foot ceiling. We then apply these adjustments, in this order:
- Sun: heavily shaded rooms take 10% off, very sunny rooms add 10%. These two figures come from ENERGY STAR.
- Climate: cool summers take 10% off, hot climates add 10% and very hot or desert climates add 20%. ENERGY STAR does not publish a climate factor; this one is ours and is deliberately modest.
- Insulation: well insulated rooms take 10% off and poorly insulated ones add 15%. This is also our own adjustment.
- Ceiling height: above 8 feet we scale by the extra volume, so a 10-foot ceiling adds 25%.
- People: add 600 BTU for each person beyond two who regularly uses the room (ENERGY STAR).
- Kitchen: add 4,000 BTU if the unit cools a kitchen (ENERGY STAR).
The result is rounded to the nearest 100 BTU. For mini splits we then pick the smallest standard capacity that covers at least 95% of the load, because inverter units can run harder for short periods and an oversized unit short-cycles and leaves the air clammy.
This is a room-by-room estimate, not a Manual J calculation. For a whole house, new ductwork or a system over 36,000 BTU, ask a licensed contractor to do a Manual J load calculation before you buy.
Frequently asked questions
What size mini split for a 2-car garage?
A typical 2-car garage of about 484 sq ft with a 9-foot ceiling needs about 13,500 BTU insulated and 17,600 BTU uninsulated. Both point to a 18,000 BTU mini split. See the 2-car garage page for climate scenarios.
Why does a garage need more BTUs than a bedroom of the same size?
Most garages have little or no wall insulation, an uninsulated door that faces the sun, a concrete slab and air leaks around the door. All of that lets far more heat in. Insulating the door and walls is often cheaper than buying the next size up.
Can I use a window unit in a garage?
Yes, for a small or occasional workshop. Mini splits are quieter, more efficient and can also heat, which is why they are popular for garages that get used year round.
Do I need to insulate the garage before adding AC?
You do not have to, but it changes the size and running cost a lot. Going from an uninsulated to an insulated garage can drop the load by about a quarter in this calculator, and it usually lets you buy a smaller unit.