BTU Bench

AC running cost calculator

Estimate what an air conditioner, mini split or heat pump costs to run per hour, day, month and year from its capacity, efficiency rating and your electricity rate.

Your space

BTU per hour from the nameplate. 1 ton = 12,000.
Mini splits often 18 to 30. Older central AC 10 to 13. Window units 10 to 16.

Estimated cost per month

—
per month at 30 days
Energy per hour
—
Cost per hour
—
Cost per day
—
Cost per year
—
Energy per year
—

Quick answer: a 12,000 BTU mini split rated SEER2 20 uses about 0.6 kWh per hour. At 17 cents per kWh and 8 hours a day, that is about $24 a month.

Monthly running cost chart

8 hours a day for 30 days at $0.17 per kWh.

Capacity (BTU)SEER2 14SEER2 20SEER2 25
9,000$26$18$15
12,000$35$24$20
18,000$52$37$29
24,000$70$49$39
36,000$105$73$59

The formula

Energy per hour (kWh) = BTU per hour ÷ (efficiency rating × 1,000)

Cost = energy per hour × hours used × electricity rate

SEER2 already reflects a typical cooling season, including the time an inverter unit spends running below full speed, so it gives a fair seasonal average. It will underestimate the hottest weeks and overestimate mild ones.

Ways to lower the cost

  • Set the thermostat a few degrees higher. Each degree typically saves a few percent of cooling energy.
  • Clean or replace filters monthly in summer. A clogged filter cuts airflow and efficiency.
  • Close blinds on sunny windows during the afternoon.
  • Size the unit correctly. An oversized unit cycles more and runs less efficiently. Use the BTU calculator first.
  • When replacing a unit, compare SEER2 ratings. Going from 14 to 20 cuts running cost by about 30%.

Frequently asked questions

How much does it cost to run a 12,000 BTU mini split?

At SEER2 20, 8 hours a day and 17 cents per kWh, about $24 a month. An older or less efficient unit costs more. Enter your own numbers above.

What is SEER2?

SEER2 is the US seasonal efficiency rating for central air conditioners and heat pumps, including mini splits. It is BTU of cooling delivered per watt-hour of electricity over a typical season. Higher is cheaper to run. Window units use CEER, which you can enter in the same field.

Why is my bill higher than the estimate?

The estimate assumes the unit runs at its rated efficiency for the hours you enter. Very hot days, dirty filters, low refrigerant, leaky ducts and a thermostat set low all raise real use. Many systems also run more hours than people expect.

Where do I find my electricity rate?

Divide the energy charges on your bill by the kWh used. Include delivery charges if they are billed per kWh. Rates vary a lot by state and country, so the default here is only a starting point.